Non-Pressure Evacuated Solar Water Heater

These Non-pressure evacuated solar water heater uses all-glasses evacuated tubes as the solar collector for absorbing solar energy and transferring it into heat energy. As the different densities of hot water and cold water, the hot water flows automatically upwards while the cold water flows down.The water flowing cycle is created in the tube .And the water in the storage tank is heated from this natural circulation. The hot water pressure of this non-pressure system is from the gravity, so it should be installed on the roof or at least 3-4 meters higher than hot water tap. Or you can install a booster pump to get stronger outlet hot water. Technical Data: Inner tank SUS 304-2B/0.41mm, I 360mm Outer tank Galvanized steel/0.41mm, I 460mm Insulation layer high density polyurethane foam 50mm Vacuunm tube 58*1800mm/SS-CU-ALN or AL-N-AL coating Bracket Galvanized steel 1.5mm with 27/30/38/45 degree installing angle Electrical heating connection(inch) 3/4 or 1 and 1/4 Water connection(inch) 1/2 or 3/4 Note: All the system are available for the customization